(SOLD OUT) Introduction to Silversmithing + Kit | Thursday Evening | April 11th – June 13th

Is this class sold out? Please join our waitlist to be the first to know when classes are going to go live for future sessions.

Thursday Evening
April 11th - June 13th
5:30pm - 8:30pm

Prerequisites: None

Be introduced to the fundamental skills of jewelry making: proper use of hand tools, torches, flex shafts, polishers and more! Learn to layout, drill, pierce, file, form, solder and polish sterling silver with individual instruction, close-up demonstrations, and hands-on experience.

The course fee for this class includes the Introduction to Silversmithing Starter Kit, which includes all required supplies*.

Items supplied in the kit are: 

• (1) 4 or 5 inch saw frame*
• 1 dozen 2/0 saw blades*
• 1 dozen 4/0 saw blades*
• 1 oz. beeswax*
• 1 each #55 and #65 drill bits*
• 1 center punch*
• (1) #1 economy half round inside ring file*
• 1 economy #2 small needle file set
• 1 particle mask*
• 1 straight edge (6 inch metal ruler)*
• 1 ultra fine line black Sharpie pen*
• (1) 1 x 3 inch 18 gauge sterling silver sheet*
• (1) 1 x 3 inch 20 gauge sterling silver sheet*
• 1 titanium solder pick (with blue handle)
• 1 small sheet easy silver solder
• 1 small sheet medium silver solder
• 1 small sheet hard silver solder
• 1 pair economy combination half-round pliers, 5 ¼ inch length with curved head approximately 6mm wide
• 5 wooden or acrylic sanding stick blanks
• 1 sheet each of 220, 320, 400, 600, & 1000 wet/dry sandpaper
• 3 small plastic cups for solder chips
• 1 economy fine tip solder tweezers
• 10 rubber bands
• 1 sheet each of graph and tracing paper
• (1) 3 inch length of 18 gauge round sterling silver wire
• 1 ring clamp
• 2 flat edge Blue Wheels
• 2 mandrels 3/32 inch with screw

See registration & cancellation policies

Please note the following guidelines:
Please do not come to class high (this includes, but is not limited to marijuana and/or alcohol). This is important on many levels, but quite simply:

• It makes technical communication difficult at best.
• Many of the tools and chemicals we use can be dangerous if not used properly.

COVID protocol:
Since there has been an uptick in cases, please make sure to keep a mask in your toolbox. At the very least you'll use it when you're polishing.

Also, if you have traveled recently, please consider getting tested and wearing a mask in class until you test negative for COVID.

Please wear your mask in class if you think you're experiencing allergies or have a cold, until absolutely sure that you don't have COVID. Thank you so much for your continued commitment to a safe and welcoming environment for all of us.

Is this class sold out? Please join our waitlist to be the first to know when classes are going to go live for future sessions.